ITI Straumann Tissue Level SynOcta® Implant Internal Titanium
Premill Blank 14mm Engaging
NN(3.5) / RN(4.8) / WN(6.5)
Material:
Ti 6AI-4V ELI (Supply from Germany)
Feature:
* Simply efficiency
* Precision machined up to ± 5µm
* Benefit from a faster and controlled turnaround time
* Different diameter available of 10mm, 14mm
Pre-milled Abutment Blanks, you can now produce titanium customised
abutments with your milling equipment.
Boost your efficiency by using your milling machines and benefit
from all major implant connections.
Approved by CE, ISO 9001, ISO 13485
* We also can provide another 3 type of premill as above picture
shown. Welcome to further inquire. Thanks.
Product Description
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 14mm are
designed to be used for the production of custom titanium
abutments.
Accessories
None
Contraindications
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 10mm should only be used for the application described.
The following conditions would contraindicate use of Inclusive
Titanium Abutment Blanks:
Wall thickness less than 0.5 mm
Gingival margin diameter less than 0.5 mm wider than the implant
Angle corrections of more than 30 degrees
Less than 0.5 mm margin height
Less than 4.0 mm post height
Hybrid abutments (zirconia abutments with titanium base) are
contraindicated by the conditions listed above, and in cases with
angle correction or gingival height greater than 6 mm. A
patient-specific finished device will consist of both the titanium
base and zirconia coping.
Sterility
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 14mm are shipped NON-STERILE. Non-sterile items must be cleaned, disinfected, and sterilized
prior to clinical use, according to a validated method.
Cleaning: Wash using a broad spectrum cleaning solution, followed by
thorough rinsing and drying.
Disinfection: Immerse abutments in disinfectant, rinse with distilled water and
dry.
Sterilization: Gravity-fed sterilizers: Autoclave in sterilization pouch for 15
minutes at 132°C (270°F). Allow sterilized components to dry for at least 30 minutes.
